Great Lakes MINISTAR S Operation Manual - Page 9

Browse online or download pdf Operation Manual for Dental equipment Great Lakes MINISTAR S. Great Lakes MINISTAR S 13 pages.
Also for Great Lakes MINISTAR S: Troubleshooting & Fabrication Tips (2 pages)

Great Lakes MINISTAR S Operation Manual
Place an adequate amount of pellets in the pellet cup to
hold the model at a proper level. Material termination areas,
located on the facial surface of the model, should be refer-
enced at the same height as the top ledge of the pellet cup.
Note: Mounted models may be referenced slightly
higher than indicated.
Remove the pellet drawer (A) from the machine by sliding
the drawer up and away from the machine.
Sliding the drawer upward positions the magnetic clip (B)
above the rim to prevent the pellets from spilling over the
edge of the machine's table.
To replace the pellet drawer, line up the groove on the back
B
of the drawer (A) with the block (B) on the magnetic clip.
A
Once engaged, slide the drawer down to its rest position in
the slots.
Pour pellets between the model and the inner wall of the
cup. Apply additional pellets in this area as needed.
Use a MiniSTAR S Brush (010-046), or MiniSTAR S Brush with
Magnet (016-021) to remove excess pellets, and level the
pellet line from the model to the top rim of the cup.
Hold the brush at an angle to sweep excess pellets from
the rim of the cup and the palatal area of the model. Sweep
excess pellets around the outside of the cup into the pellet
drawer.
9