Daxten Voyager 300 Installation Manual - Page 6

Browse online or download pdf Installation Manual for Extender Daxten Voyager 300. Daxten Voyager 300 8 pages. Kvm extender up to 100 or 300m
Also for Daxten Voyager 300: User And Installation Manual (16 pages), Brochure (2 pages)

Print Page
Connecting Up
1.
Switch off your computer.
2.
Connect the Voyager Local Unit to the PC KVM Cable
3.
Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and
Mouse ports on the Voyager Local Unit. (You can use the Voyager without having a Local
Keyboard, Monitor and Mouse connected).
4.
Connect your UTP cable to the Voyager Local Unit.
5.
Connect the PC KVM cable to your computer's Keyboard Monitor and Mouse ports.
6.
Connect the other end of your UTP cable to the Voyager Remote Unit.
7.
Connect the power supply unit to the Voyager Remote unit.
8.
Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and
Mouse ports on the Voyager Remote Unit.
9.
Power on your computer.
10. Check that the keyboard and mouse operate correctly.
11. Adjust the Video Equalisation if required on the Voyager Remote Unit which contains video
equalisation circuitry that will compensate for the loss in image quality experienced when
sending video over long cables..
To set the correct level of equalisation there are two adjustments on the front panel of the Voyager
Remote Unit. Adjust the Distance to the appropriate cable length, and then adjust the Eq to fine tune
the setting (these only need to be set once.)
The remote unit (when installed in its final location) may be left permanently powered up.
In order to make the distance settings as easy as possible, the Voyager 300 incorporates three boost
steps, which means there will be a big gain jump when the LED's change.
Always try the EQ adjustment before and after the LED's change, to achieve the
Note:
best picture quality.
Always adjust the EQ after you have adjusted the Distance setting.
The distances indicated by the LED are only guidelines, as cables can differ in their
quality.
Please note that for all practical purposes cable equalisation cannot be exact - the remote image will
never be as sharp as the original.
Front Panel Layout Voyager 300 Remote Unit
LED
No Light
Led 1 On ─
80 – 220 m
Led 2 On ═
190 – 350 m
Cable Length
0 – 100 m
0 – 350 ft
250 – 725 ft
600 – 1200 ft