Daxten VOYAGER DVI EXTENDER Installation Manual - Page 4

Browse online or download pdf Installation Manual for Extender Daxten VOYAGER DVI EXTENDER. Daxten VOYAGER DVI EXTENDER 8 pages. Dvi kvm extender for lcd displays
Also for Daxten VOYAGER DVI EXTENDER: Brochure (2 pages)

Print Page
The UTP / STP interconnect cable to connect the Voyager DVI Local Unit to the Voyager DVI Remote
Unit is not supplied with the Voyager DVI units. If you do not have suitable CAT 5, 5E or 6 UTP or STP
cable fitted at you site, please consult your dealer.
The Local and Remote Units are connected by industry standard structured cabling (Category 5, 5E or
6 UTP/STP, 4-pair) terminated with RJ45 connectors.
The cable used should be solid trunk cable. Stranded patch cable will give poor results over longer
distances.
The connector wiring must meet the EIA/TIA 568 standard.
CAT5 Wiring Scheme
The Local-Remote interconnection cable is terminated in RJ45 connectors and should be wired
according to the EIA/TIA 568 (Scheme B preferred) industry standard. The Voyager will function with
other wiring schemes, but the video quality may be impaired.
Orientation: Looking into the RJ45 socket pin 1 is on the left and pin 8 on the right.
Pin
Wire Colour
1
White/Orange
2
Orange/White
3
White/Green
4
Blue/White
5
White/Blue
6
Green/White
7
White/Brown
8
Brown/White
The Voyager has been tested with all major makes of CAT 5 cable including BICC-VERO, Mohawk,
and Brand-Rex. The Voyager has also been tested with most major makes of CAT 5E and CAT6 with
good results.
Note:
That failure to wire the twisted pairs correctly will impair the video quality
dramatically and / or prevent correct operation.
This Voyager DVI extender is designed for use up to a maximum cable length of 150m / 500ft At this
length the video quality should still be acceptable even at a screen resolution of 1600 x 1200 (60 Hz).
Although a single continuous length of interconnect cable is preferable, operation is possible through
multiple Patch Panels. However, the more patch panels the cable is routed through, the greater the
chance of video signal degradation.
Diagnostic LEDs on the Voyager DVI
LED
Power LED (Red)
Video LED (Green)
Link Status (Green)
(Right LED on RJ45 connector)
Data Status (Green)
(Left LED on RJ45 connector)
Wire
Pair
T2
2
R2
2
T3
3
R1
1
T1
1
R3
3
T4
4
R4
4
Appearance
Off
On
Off
On
Blinking
On
Blinking / On
Off
Diagnostics
Device not ready
Device Ready
No Signal or Invalid Signal
Device Ready
No CAT5 Connection
Device Ready
Data Error – Cable to long or too much
interference etc.
Device Ready