Gaggenau VG 232 234 AU Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Cooktop Gaggenau VG 232 234 AU. Gaggenau VG 232 234 AU 12 pages.
Also for Gaggenau VG 232 234 AU: Installation Instructions (4 pages)

Print Page

Control knob

Special accessories

You can order the following special accessories from

your specialist dealer:

▯

SH 260 001

Hinge holder for fitting the appliance cover

▯

VD 201 034

aluminium appliance cover

(for VG 264: two appliance covers necessary)

▯

VV 200 034

aluminium connection strip for combination with

further Vario appliances

Only use the accessories as specified. The

manufacturer accepts no liability if these accessories

are used incorrectly.

Burner assembly

Always assemble the burner parts correctly and evenly

to avoid faults during ignition or during use. The

catching pins on the burner ring must fit in the

corresponding holes on the burner head.

Burner assembly normal / high output burner

The markings show the

position of the corresponding

burner and the setting

between high and low heat.

The flame setting is infinitely

variable between high and

low.

EXUQHU OLG

EXUQHU KHDG

VSDUNHU

KHDW VHQVRU IRU

IODPH PRQLWRULQJ

Operation

The markings on the control knob show the setting

between high and low heat. The flame setting is

infinitely variable between high and low heat.

Notes

‒

Only light a burner if all pan supports and burner

parts are properly assembled.

‒

Make sure the burners and ignition sparkers are

clean and dry.

‒

Fully press down the control knob and keep it

pressed, then turn it to the required position.

‒

After igniting, keep the control knob pressed for

around 2 to 4 seconds more. The thermal sensor

which controls the gas flow must be heated

before the knob can be released.

‒

If the flame should not ignite within 2 to 4

seconds, turn the control knob further to the left

to the low heat position and then back to the high

heat position after ignition. It is often faster to

ignite the burner in the low heat position because

the various gases have a differing ignition

response.

‒

If ignition fails depress knob and try again. If

flame is not established in 15 seconds release

the control knob and open a door and wait

1 minute before attempting a new ignition

procedure.

‒

Only use the recommended accessories. Do not

cover the stainless steel cooktop base (e.g. with

aluminium foil).

Abnormal operation

Flames are usually blue and sharply defined. If the

flames are yellowish or noisy or if the gas does not

ignite within the period specified under "switching on"

abnormal operation is indicated. Refer to chapter

"After-sales service" of this manual for service contact

details.

Switching on automatically

Your cooktop features ignition sparkers for automatic

ignition.

Place a suitable pot or pan on the corresponding

cooking position.

Fully press down the corresponding control knob

and turn it anticlockwise to the required position.

The burner lights automatically.

Keep the control knob pressed for a few seconds

after ignition.

The flame size can be set continuously between high

and low by slowly turning the control knob.