Gaggenau VG 232 AU Instruction Book - Page 3

Browse online or download pdf Instruction Book for Cooktop Gaggenau VG 232 AU. Gaggenau VG 232 AU 19 pages. Built-in gas cooktop
Also for Gaggenau VG 232 AU: Instruction Book (19 pages)

Print Page

Warnings

1. Do not allow the flame to extend beyond the

edge of the cooking utensil. This instruction is

based on safety considerations.

2. Do not forget that the unit becomes hot when in

use. Common sense is important. Just because

the flame is out, it does not mean parts still

cannot be hot.

3. This appliance shall not be used for space

heating. This instruction is based on safety

considerations.

4. Be sure to disconnect the electrical supply

before disassembly of the appliance.

5. Keep the appliance area clear and free from

combustible materials, gasoline and other

flammable vapors and liquids.

6. Do not obstruct the flow of combustion and

ventilation air.

7. Cabinets installed above the gas cooktop must

have a minimum clearance of 600 mm (24").

8. The gas pressure regulator supplied with the

appliance must be installed in line with the gas

pipe.

9. The appliance and its individual shutoff valve

must be disconnected from the gas supply

piping system during any pressure testing of the

system at test pressures in excess of 3.5 kPa

(1/2 psig). The appliance must be isolated from

the gas supply piping system by closing its

individual manual shutoff valve during any

pressure testing of the gas supply piping system

at test pressures equal to or less than 3.5 kPa

(1/2 psig).

10.Important:

When using a very large pot, leave a gap of at

least 50 mm (2") to avoid damaging any parts in

counter top wood, plastic or other non-heat-

resistant materials. Never leave oil or hot fat

unattended.

All manuals and user guides at all-guides.com

Note:

To avoid jeopardising the electrical safety of the

appliance, it is forbidden to use high-pressure or

steam jet cleaning devices.

Note:

The name plate is attached to the bottom of the unit

and to the inside of the housing.

This installation must conform with the following:

Manufacturer's installation instructions,

local gas fitting regulations,

municipal building codes,

the A.G.A installation code for gas burning appliances,

the S.A.A. wiring code,

local electric regulations and

any other statutory regulations.