Daxten SCOUTaudio 2095-03PA Installation Manual - Page 4

Browse online or download pdf Installation Manual for Switch Daxten SCOUTaudio 2095-03PA. Daxten SCOUTaudio 2095-03PA 7 pages.

Print Page

2. Connecting the console devices:

2.1.

Connect your monitor's HD 15-pin connector to the SCOUTaudio's Monitor 'CONSOLE' device on

the rear panel.

2.2.

Connect your PS/2 keyboard to the PS/2 keyboard connector (purple) and your PS/2 mouse to the

PS/2 mouse connector (green) on the rear panel of the SCOUTaudio.

2.3.

Connect your speakers to the audio connector and connect your microphone to the microphone

connector.

3. Connecting the computers with PS/2 ports via the SCOUT KVM cable:

3.1.

Connect the DB 15-pin male connector to the next free PC port on the rear panel of the

SCOUTaudio (labelled PC1, PC2...).

3.2.

Connect the blue HD 15-pin male connector to the VGA port on your computer.

3.3.

Connect the purple PS/2 (6-pin MiniDIN) keyboard connector to the PS/2 keyboard port on your

computer. NOTE: for USB ports, please see Step 4

3.4.

Connect the green PS/2 (6-pin MiniDIN) mouse connector to the PS/2 mouse port on your

computer. NOTE: for USB ports, please see Step 4

4. Connecting the computers with USB ports via the SCOUT KVM cable:

4.1.

Connect the DB 15-pin male connector to the next free PC port on the rear panel of the

SCOUTaudio (labelled PC1, PC2...).

4.2.

Connect the blue HD 15-pin male connector to the VGA port on your computer.

4.3.

Connect the PS/2 keyboard connector (purple) to the Daxten PS/2 to USB adaptor.

4.4.

Connect the PS/2 mouse connector (green) to the Daxten PS/2 to USB adaptor.

4.5.

Connect the USB connector to a USB port on your computer.

5. Connecting the speaker and microphone cables.

5.1.

Connect the speaker cable to the audio port on the SCOUTaudio (labelled PC1, PC2...).

5.2.

Connect the microphone cable to the microphone port on the SCOUTaudio (labelled PC1, PC2...).

5.3.

Connect the speaker cable to the audio port on your computer.

5.4.

Connect the microphone cable to the microphone port on your computer.

6. Power up the computers. The computer connected to the first port will be shown on the monitor. You may

check if the keyboard and mouse work after the system has booted up. If this is OK, use the Select button

to select the following computers to verify keyboard and mouse functionality.

keyboard or mouse are not working correctly please verify that all cables are properly connected.

Using the SCOUTaudio

The SCOUTaudio provides two possibilities to select the desired computer. You may use either the Select

button on the unit, or make use of the keyboard Hot Key commands.

You may notice that the mouse cannot be used for around 2 seconds when the S COUTaudio switches to

another computer. This is normal and is caused by the synchronization process which ensures that the mouse

operates correctly.

Selection buttons

2 Port: Pressing the Select button on the front panel cycles through computers 1 ~ 2.

4 Port: Pressing the individual PC buttons will switch the signal to the desired computer.

If you find that the