6TL YAV904X8 Technical Description - Page 9

Browse online or download pdf Technical Description for Multiplexer 6TL YAV904X8. 6TL YAV904X8 13 pages. 4 banks 2-pole 2a 1 to 8 multiplexer

Print Page

LED BEHAVIOUR

LED Name

LED Behaviour

STATUS

Off

Solid green

Blinking green

LED behaviour

SWITCH CONFIGURATION

Switch

Name

SW1

1 & 2

3 to 8

SW1 behaviour

Switch ID

SW2

BOOT0

SW3

RESET

SW4

CAN-END

Switches description

Board is not powered on or power supply is not reaching the

microcontroller.

Board is powered on, but firmware of microcontroller is not present or

is not running due an error.

Board is powered on and firmware is running properly.

Pin switch

Switches 1 and 2 set the CAN communication speed:

The logic address is composed by 2 elements: the module

identification and the hardware address. The module identification is

set on firmware and cannot be changed. The hardware address is

selected by switches 3 to 8, being 3 the least significant bit (LSB) and

8 the most significant bit (MSB):

Description

Factory use. Must be OPEN on operation.

Must be OPEN on operation. A temporary bridge causes a reset of the board.

Placing jumper adds a 120 Ohm resistor between the CAN-High and CAN-Low

signals of CAN-Bus.

Definition of Behaviour

00 = 50 kbps

10 = 100 kbps

01 = 125 kbps

11 = 250 kbps

ON=1

OFF=0

1 2 3 4 5 6 7 8

LSB

MSB

Board Address

Definition of Behaviour