Gaggenau AI201102 Operating And Assembly Instructions Manual - Page 14

Browse online or download pdf Operating And Assembly Instructions Manual for Ventilation Hood Gaggenau AI201102. Gaggenau AI201102 20 pages.

Print Page

6. Assembly instructions

6.1

Technical data

AI 200:

max. weight depending on version 45 kg

dimensions

AI 201: max. weight depending on version 45 kg

dimensions

AI 202: max. weight depending on version 43 kg

dimensions

AI 203: max. weight depending on version 43 kg

dimensions

Electrical connection

Pay attention to the rating plate data.

The mains connecting cable must at least

correspond to the type H 05 VV-F G 0,75.

The appliance must only be connected by an

authorised specialist. The specialist is

sible for perfect functioning of the appliance at its

installation location. He must explain the operating

principle of the appliance to the user with refe-

rence to the operating instructions. He must explain

to the user how the appliance can be isolated from

the mains whenever required.

Connection possibilities

The plug of the connecting cable is inserted into

the socket on the ceiling. If this is not possible, the

disconnection of all the poles of the appliance from

the mains must be possible by way of the domestic

fuse, or by using an accessible disconnecting device

with a contact gap of at least 3.0 mm.

998 x 648 mm

respon-

6.2 Installation

The applicable regulations of the energy supply

companies and the

regional construction

regulations

must be observed when installing

the hood.

The

minimum distance from the cooking surface

to the bottom edge of the extractor hood is 600 mm

for electrical appliances. The

from the bottom edge of the pot stand to the bottom

edge of the extractor hood is 650 mm for gas

appliances.

The hood can be used in the exhaust or circulating

air mode . The exhaust air can be routed into a

separate exhaust air shaft or directly into the open

through the outside wall.

It is not allowed to pass the exhaust air into a flue

or exhaust air chimney that is in operation or into a

shaft that is linked to the heating basement. Consult

the chimney sweep responsible for your district

whenever you wish to pass the exhaust air into a

chimney that is not in operation.

During the course of planning, a chimney sweep

must be consulted if a room air-dependent hearth

is operated in the same room as the one in which a

hood is operated in the exhaust air mode. Adequate

incoming air must be ensured. The applicable

construction and safety regulations must be

observed.

Adequate incoming air must be ensured if a wood,

coal, gas or oil heater or an open hearth is operated

in the same room as the one in which the hood is

installed.

Safe operation is possible whenever the partial

vacuum in the place where the firing equipment

is installed does not exceed 4 Pa (0.04 mbar).

This can be achieved whenever the air needed for

combustion is able to enter through openings that

cannot be sealed, for example in doors, windows,

incoming/exhaust air wall boxes or other technical

means.

minimum distance