Gaggenau AT 400 Operating Instructions Manual - Page 12

Browse online or download pdf Operating Instructions Manual for Ventilation Hood Gaggenau AT 400. Gaggenau AT 400 16 pages. Table ventilation

Print Page

Cleaning the grease filters

The grease filter saturation display F flashes after

an operating time of 10 hours to indicate that you

should clean the grease filters.

Depending on the cooking habits it may be

necessary to clean the grease filters at shorter

intervals (for example if kitchen smells appear when

the ventilation is switched off).

The centrifugal grease filters can be easily removed

for cleaning:

Disconnect the appliance from the mains

(switch off fuse).

Tilt the ventilation panel to the rear. For easier

cleaning you can remove the panel: On both

sides of the panel at the top, lift over the studs

and remove to the front.

Remove the centrifugal grease filters one by

one (from right to left).

Remove the grease collecting trays (from right

to left) and empty.

You can clean the centrifugal grease filters and the

grease collecting trays in a dishwasher. Place the

filters upright ín the dishwasher, with the opening

face down.

Wipe out the inner parts of the housing with a moist

cloth and some detergent when removing the filters.

Caution: Beware of protruding parts when cleaning

the inside of the housing.

Do not pour any liquid into the housing. If liquid

accidentally enters the housing, it will reappear at

the base.

Refit the grease filters in the correct order (from left

to right). Refit the parts so that the markings

correspond with the markings on the housing.

Press the F key to reset the counter. Flashing of the

indicating lamp goes off.