Gaggenau AT 400-730 Use And Care Manual - Page 13
Browse online or download pdf Use And Care Manual for Ventilation Hood Gaggenau AT 400-730. Gaggenau AT 400-730 16 pages. Backsplash ventilation
Also for Gaggenau AT 400-730: Installation Instructions Manual (16 pages)
Print Page
Cleaning the Grease Filters
The grease filter saturation display F flashes after
an operating time of 10 hours to indicate that you
should clean the grease filters.
Depending on the cooking habits it may be
necessary to clean the grease filters at shorter
intervals (for example if kitchen smells appear when
the ventilation is switched off).
The centrifugal grease filters can be easily removed
for cleaning:
1
Disconnect the appliance from the power
supply (switch off fuse).
2
Tilt the ventilation panel to the rear. For easier
cleaning you can remove the panel: On both
sides of the panel at the top, lift over the studs
and remove to the front.
3
Remove the centrifugal grease filters one by
one (from right to left).
4
Remove the grease collecting trays (from right
to left) and empty.
You can clean the centrifugal grease filters and the
grease collecting trays in a dishwasher. Place the
filters upright in the dishwasher, with the opening
face down.
Wipe out the inner parts of the housing with a moist
cloth and some detergent when removing the filters.
Caution: Beware of protruding parts when cleaning
the inside of the housing.
Do not pour any liquid into the housing. If liquid
accidentally enters the housing, it will reappear at
the base.
Refit the grease filters in the correct order (from left
to right). Refit the parts so that the markings
correspond with the markings on the housing.
Press the F key to reset the counter. Flashing of the
indicating lamp goes off.
13