Aircraft Espresso AC-755 Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Coffee Maker Aircraft Espresso AC-755. Aircraft Espresso AC-755 9 pages. Espresso machine with pid to be used with ground coffee/pods

Print Page
27.
Fit the pod filter (18) into the filter holder (8) that has been warmed up by leaving it attached to the brewing
group as described in point 7.
28.
Open the single packed pod and pay attention not to damage the pod.
29.
Place the pod in its filter (18).
30.
Insert the filter holder (8) in the brewing group ring (5), turn it from left to right with force, then put the cup
on the removable water drainage tray (7).
31.
Position the lever switch (13) on coffee and lift the pump switch (22). The manometer (17) will show the
reached pressure, between 8 and 14 bar.
32.
Once you get the desired quantity of coffee, push down the switch (22) again.
33.
Remove the filter holder (8) and throw away the used pod.
Steam:
34.
Check that the water tank (1) has been filled in with water by looking at the water level indicator (20).
35.
Press the on/off switch (11): the indicator light of the switch (11) will come on. Do this operation only if the
machine is off. If it's on pass to the following point.
36.
Position the lever switch (13) on steam mode.
37.
As soon as the light (14) goes on, the machine is ready for use.
38.
Open the steam/hot water knob (4). First some water will flow out and then the steam.
39.
Put the cup with the desired infusion under the steam tube (6) and turn the knob (4) completely.
40.
When the drink has been suitably frothed, close the steam/hot water knob (4).
41.
IMPORTANT: after you have frothed your milk, reopen the steam/hot water knob (4) and position the steam
switch (13) on hot water, and lift up the pump switch (22). When the water flows out of the steam tube (6),
close the steam/hot water knob (4) again and at the same time push down the switch (22) and re-position the
switch (13) on coffee again. Clean carefully the steam/hot water tube (6). This operation is needed in order to
restore the water circuit inside the machine's tubes.
Hot water:
42.
Check that the water tank (1) has been filled in with water by looking at the water level indicator (20).
43.
Press the on/off switch (11): the indicator light of the switch (11) will come on. Do this operation only if the
machine is off. If it's on pass to the following point.
44.
Position the lever switch (13) on hot water.
45.
As soon as the PID's display (21) shows the set temperature and the indicator light (14) remains on, the
machine is ready for use.
46.
Open the steam/hot water knob (4) and lift the pump switch (22).
47.
Hot water will flow out from the steam arm (6) immediately.
48.
Once you have got the desired quantity of water, repress the switch (22) and close the steam/water knob (4).
49.
After obtaining hot water from the arm (6), make sure that there is still water in the tank (1).
HOW TO SET THE BOILER'S TEMPERATURE BY MEANS OF THE PID:
The PID has been set by the producer of this machine on a temperature of 95°C. In order to change the temperature
please proceed as follows:
press the button
-
as soon as the display shows the boiler's temperature, help yourself with the buttons
-
order to set the desired temperature, starting from a min. of 80C° up to a max. of 130C°.
after 3 sec. from pressing the last button, the inserted temperature is memorized and the display shows the
-
set temperature.
NB: if the temperature is set too high, once a coffee request is made, the display starts to flash.

USEFUL TIPS:

The single cup filter (9), the two cup filter (10) and the pod filter (18) do not need to be washed after each
-
use but please check that the holes are not blocked.
For best results, we suggest warming the cups up on the cup warmer (2) which works only when the machine
-
is on.
The PID is already set by the producer on the right temperature for an excellent espresso. During heating and
-
coffee or water distribution, the temperature can oscillate (+/- 10/12°C). Also, a warning has been inserted:
after 108°C the PID's display shows the temperature but intermittently; this is normal and it warns the user
that the coffee will not be good if made with such high temperature.
ROUTINE MAINTANCE AND PRECAUTIONS:
It is recommended to clean, after each use, the steam arm (6) and the strainer holder (8) carefully.
-
For cleaning it is recommended the use of a wet damp cloth.
-
-
Do not leave the machine outdoor. And do not immerse the machine in water.
-
The machine can be used only by adults and must be kept away from children.
-
Do not wash strainer and strainer holder in dishwasher
; as soon as the display shows the writing "PRG" press the button
English
;
and
in
Page 3