Dynabrade 50727 Manual - Page 4

Browse online or download pdf Manual for Grinder Dynabrade 50727. Dynabrade 50727 4 pages. 4 hp/right-angle/rear exhaust 2" depressed center wheel grinder

Print Page
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
Disassembly/Assembly Instructions - (continued)
14. Using a 34.0 mm crow foot and a torque wrench set at (34 N•M/300 in. - lbs.), secure the gear case housing and lock nut in place.
15. Press 54520 Bearing and then gear onto spindle shaft, making sure drive hexes are aligned.
16. Place 01486 Silencer over spindle shaft at threaded end.
17. Slip bottom wick over spindle shaft, then place top wick over spindle shaft.
18. Insert spindle shaft assembly into 02031 Housing.
19. Torque 02035 Lock Nut to 23 N•m, 200 in. - lbs
20. Shim spindle assembly using shims if required.
Note: When assembling angle-head assembly onto the motor housing, make sure flats on the wicks are both facing the pinion or tool will not run.
Tool Assembly is complete. Please allow 30 minutes for adhesives to cure before operating tool.
Important: Before operating, place 2-3 drops of Dynabrade Air Lube (P/N 95842) directly into air inlet with throttle lever depressed. Operate tool for
30 seconds to determine if tool is operating properly and to allow lubricating oils to properly penetrate motor. Motor should now be tested for proper operation at
90 PSI. If motor does not operate properly or operates at a higher RPM than marked on the tool, the tool should be serviced to correct the cause before use.
Loctite
is a registered trademark of Loctite Corp.
®
96179 Motor Tune-Up Kit
•
Includes assorted parts to help
maintain motor in tip-top shape.
Dynaswivel
®
•
Swivels 360° at two locations which allows an
air hose to drop straight to the floor, no matter
how the tool is held.
•
94300 1/4" NPT
Visit our Web Site: www.Dynabrade.com
DYNABRADE, INC., 8989 Sheridan Drive • Clarence, NY 14031-1490 • Phone: (716) 631-0100 • Fax: 716-631-2073 • International Fax: 716-631-2524
DYNABRADE EUROPE S.àr.l.,
© DYNABRADE, INC., 2000
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
Accessories
Zone Artisanale • L-5485 Wormeldange—Haut, Luxembourg • Telephone: 352 76 84 94 • Fax: 352 76 84 95
Dynabrade Angle Gear Oil
•
Specifically formulated to saturate wick system in right
angle gear head.
•
95848: 2 oz. tube
•
95849: 10 oz. tube
52296 Repair Collar
•
Specially designed collar for use in vise to prevent damage
to valve body of tool during disassembly/assembly
®
DYNABRADE
PRINTED IN USA