GREAT PLAINS 6329UC Adjustment Manual - Page 2

Browse online or download pdf Adjustment Manual for Farm Equipment GREAT PLAINS 6329UC. GREAT PLAINS 6329UC 3 pages. Tillage

Print Page

Unfolding The Implement:

1) Be aware of the vertical and horizontal clearances needed

to unfold the implement.

2) Remove the transport wing pins and store them in their des-

ignated spots.

3) Put the track in Park and slowly begin to unfold the imple-

ment while watching for any signs of leaks or loose fittings.

4) Continue unfolding until both wings are fully extended and

level on the ground.

5) Set the tractor remote to Neutral to lock the wings.

Folding The Implement:

1) Move the implement to level ground and be aware of the

vertical clearance needed to fold the implement.

2) Put the track in park and slowly begin to fold the wings.

3) Continue folding until the wings rest within the transport

nests.

4) Install the transport wing pins before transport the imple-

ment.

Center And Wing Leveling: Leveling of the machine should

be done on a smooth level surface. Lower the implement so

that the sweeps on the center frame are 1-2" off the ground.

Wing Leveling:

1) Set the 3-section and 5-section inner and outer wings to

match the depth of the center section. This can be done by

adjusting the rear wing turnbuckle on (1) each wing.

2) Loosen the jam nut (2) and begin adjusting the turnbuckle

(1). Lengthen the turnbuckle tube to run deeper and shorten

the turnbuckle to run shallower.

3) Tighten the jam nut (2) back against the turnbuckle tube to

hold the adjustments in place. Note: In some conditions the

wings will need to be set slightly lower than the center section,

as the center section may ten to run deeper behind the tractor

tires.

Center And Wing Gauge Wheel Adjustments:

1) Loosen the jam nut (3) and adjust the turnbuckle (4) on the

gauge wheels to level it from front to back. Lengthen the turn-

buckle to bring the front up or shorten the turnbuckle to bring

the front down.

2) Level the machine with the front row shanks just slightly

deeper or lower than the back.

3) Re-tighten the jam nut (3) back against the turnbuckle.

Document

#TLUS400C-0001A

48649

48650

48651

2 of 3