Dynabrade 65750 Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Grinder Dynabrade 65750. Dynabrade 65750 7 pages. 2" wide x 48" long abrasive belt machine
Also for Dynabrade 65750: Instruction Manual (7 pages)

Print Page

ARRANTY

Following the reasonable assumption that any inherent defect which might prevail in a product will become apparent

to the user within one year from the date of purchase, all equipment of our manufacture is warranted against defects

in workmanship and materials under normal use and service. We shall repair or replace at our factory, any equipment

or part thereof which shall, within one year after delivery to the original purchaser, indicate upon our examination to

have been defective.

Our obligation is contingent upon proper use of Dynabrade tools in accordance with factory recommendations,

instructions and safety practices. It shall not apply to equipment which has been subject to misuse, negligence,

accident or tampering in any way so as to affect its normal performance.

Normally wearable parts such as bearings, contact wheels, rotor blades, etc., are not covered under this warranty.

LECTRICAL

ARNING

Warning: This tool does "not" come equipped with overcurrent protection. It is the user's responsibility to provide an

adequately grounded circuit with correctly rated fuse or circuit breaker. A "ground-fault" protected device is also

recommended if tool is to be operated "wet".

Refer to Electrical Schematic ES-65014 for machine wiring. A qualified electrician can determine if the tool (as shipped)

and the supply circuitry is in accordance with local electrical codes and ordinances.

The machine "as shipped" is intended to be used exclusively on a 230-volt, Single Phase power supply.

Always disconnect tool from power at plug before performing any maintenance tasks.

Electrical Schematic ES-65014

230 V

1 Phase

60 Hz

OPT.

DPST

Nema Configuration

Locking Type Plug

L6 – 2OP