Hi-Tech 22-225 Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Saw Hi-Tech 22-225. Hi-Tech 22-225 16 pages.

Print Page

OPERATING INSTRUCTIONS

Replace the saw table, making sure all four

tapered pins are secured. Insert the black

spray shield (part #7) into the slot located at the

front of the saw table (Fig. C). The spray shield

can be inserted in either direction.

Before turning your trim saw on, manually

spin the saw blade towards you to make

sure the blade is not in contact with the saw

table. If there is contact, see page 11 for

instructions on how to position the saw blade

for clearance. Note: Thin saw blades tend to

wave side to side as you spin them. While this is

the nature of thin saw blades, the wave can also

be caused by over-tightening the saw knob.

Fig. C

Put on safety goggles (not included), then

turn on the machine by turning the power

knob clockwise. Adjust the speed of your saw

blade using the speed chart on page 6 as a guide.

Never exceed the saw blade's maximum rpm.

There should be a fine mist coming from your

saw blade while it spins. If there isn't, pour

additional water over the blade until there is a

mist. Note: In use, always make sure the saw blade

is properly lubricated. Never run dry.

After each use, turn off the machine, then

unplug your trim saw from its power source.

Drain the water reservoir. Dry the machine and

saw blade with paper towels or a cloth. You may

also spin dry the saw blade by running it on the

trim saw until it is completely dry. Notes: Always

dry your saw blade after each use to prevent

rusting. Keep out of reach of children.