Dynabrade Mini-Raptor Vac 61100 User Manual - Page 7
Browse online or download pdf User Manual for Vacuum Cleaner Dynabrade Mini-Raptor Vac 61100. Dynabrade Mini-Raptor Vac 61100 14 pages. Wet/dry vac commercial use 16 u.s. gallon 60.5 liter
Print Page11. Secure with four screws
provided. FIGURE 9.
FIGURE 9
12. If flat washers are included in hardware package,
place one flat washer over stem of each caster.
NOTE: Flat washers are not required with all units.
13. Insert casters into front of dolly
by placing stem of casters into
holes provided. Apply pressure and
twisting motion until casters snap
into place. FIGURE 10.
FIGURE 10
14. Return tank to upright position.
CARRIAGE HANDLE
ASSEMBLY
(Not standard)
You will find one carriage handle FIGURE 13 and a
handle pack containing two side tank handles
FIGURE 14, four handle supports FIGURE 15 and
eight screws. Assemble as follows:
FIGURE 13
FIGURE 14
11. Take two handle supports and
two 1" screws. Place screws through
the hole provided in center of each
support. FIGURE 16.
FIGURE 16
12. Position the tank, in the upright
position, with the inlet facing you.
Put the support assemblies inside
the tank, then place the screws
through the holes provided on left
side of the tank. Make sure the
FIGURE 17
plastic portion is located inside the
tank. Turn the supports until the
back of the supports fit flush against the inside curve
of the tank. FIGURE 17.
PAGE 7
PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
FIGURE 18
end of the handle must face the rear of the tank. Secure
the handle to the tank with the screws in the support
assemblies. FIGURE 18.
14. Repeat steps 11 to 13 using right side of tank and
the remaining handle marked with the letter R.
FIGURE 19
Make sure carriage handle is in the U-shaped cut on the
tank handles (located towards rear of unit). Secure with
1½" screws provided. FIGURE 19.
HOSE HOLDER
INSTALLATION
(Not standard)
FIGURE 20
FIGURE 15
FIGURE 21
FIGURE 22
GENERAL SET UP
19. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
13. Remove any webbing that
attaches the tank handles to each
other. Take the side tank handle
with the letter L and position it on
the outside of the tank where the
support assemblies are installed.
The U-shaped cutout on the bottom
15. Position metal carriage handle
outside of tank and under the tank
handles. Be sure to spread ends of
carriage handle when assembling
to prevent damage to tank. Line up
holes in ends of carriage handle with
holes in bottom of tank handles.
16. With rear of unit facing you, take
hose holder and position it with tabs
facing rear of unit.
FIGURE 20 .
17. Place "J" shaped tabs into the
slots on cord wraps. FIGURE 21.
Press down until tabs snap into
place.
18. Press down on center of hose
holder until tab latches on bottom of
tank cover. FIGURE 22.
Dynabrade, Inc. 8989 Sheridan Drive
|
Clarence, New York 14031
|
dynabrade.com