GREAT PLAINS Terra Max HT1100-20 Field Adjustment Manual - Page 3

Browse online or download pdf Field Adjustment Manual for Seeders GREAT PLAINS Terra Max HT1100-20. GREAT PLAINS Terra Max HT1100-20 6 pages. Tillage
Also for GREAT PLAINS Terra Max HT1100-20: Assembly Manual (8 pages)

Print Page

GREAT PLAINS Terra Max HT1100-20 Field Adjustment Manual

Wing Adjustment Turnbuckle:

Note: Prior to leveling the wings, ensure that the

machine is level front to rear.

1) Lower the machine until the coulter gangs are 1-

2" off of the ground.

2) Loosen the jam nuts, and adjust the wing turn-

buckles (shortening the turnbuckles lowers the

wings and extending the turnbuckles raises the

wings) to match the center frame.

3) Once the machine is leveled side to side, any fur-

ther adjustment in the field should be down with the

hydraulic down pressure.

an angle and the wings are going too deep, hydrau-

lic weight transfer should be switched to float.

Wing Fold Assist Proximity Sensors Adjustment

(If Installed):

Note: Wings must be folded up and the wing safety

lock pins installed when adjusting the proximity sen-

sors to prevent damage to the sensor and bracket.

1) Loosen the nuts (one on the front and one on the

back side of the sensor bracket, adjust the proximity

sensor to 1/8" to 1/4" from the front of the proximity

sensor to the rear of the wing tube).

2) Once adjusted, re-tighten the nuts to secure the

proximity sensor in position.

Proximity sensors have built in diagnostic LED's. If

the RED LED is illuminated, the switch is activated

(sensor sees metal). If the GREEN LED is illumi-

nated, the switch is not activated (sensor doesn't

see metal). The switch must have 12+V for the sen-

sors to work which is powered by the light plug.

Note: If running gangs at

49659

49366

3 of 6

Document

#TLUS625C-0001B