DynaColor EDNS V3000 Setup Manual - Page 9

Browse online or download pdf Setup Manual for DVR DynaColor EDNS V3000. DynaColor EDNS V3000 14 pages.

Print Page

Dome Camera Control

Dome Camera Connection & Settings:
 See section Pin Definition of Alarm Iuputs & RS-485, and Alarm Outputs for RS-485 port pin
definition.
 Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
 To set up dome camera's protocol and ID, press Menu to access the OSD main menu, and
select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding
protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number
must match the ID address defined by the dome camera.
 To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then
select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1
Iris Close
2
Iris Open
3
Focus Far
4
Focus Near
5
Zoom Out
6
Zoom In
7
Esc
Enter Dome Camera
8
Control Mode
9
Enter / Auto
10
Pan / Tilt
11
Set / Go Preset
12
Go Presets 1~6
9