AFFORDABLE LIFTS E9997 Assembly And Installation Manual - Page 9
Browse online or download pdf Assembly And Installation Manual for Lifting Systems AFFORDABLE LIFTS E9997. AFFORDABLE LIFTS E9997 15 pages. Affordable lift
7.6. Move to installation site: Move the lift and its parts to the lift installation site.
7.7. Weather: Electrical components should be protected from weather until properly installed.
8. Position Your Lift
8.1. Move and orient the lift to the position where it will be used. Do NOT anchor it at this time.
8.2. If your Wheel Kit is installed, remove and store the wheels now. Do NOT use the lift while the wheels are attached.
8.3. The back of the Column should be at least 3" from any vertical plane of a wall or obstruction so that the Collar can move
freely. Note that walls are often not truly vertical! The Platform, the Collar and everything attached to them must have
enough clearance to go up and down their travel height without hitting any obstructions.
8.4. Use steel or plastic shims (not included) to make the Column plumb.
8.5. The edge of the Platform, when at the station height, should come to approximately 0.5" (1/2") of the edge of the landing.
Note that many landing edges are not actually square or level.
Below is a typical assembled freestanding lift, positioned for use and with a ground transition ramp in place. Note the shim
9. Electrical Power
9.1. Warning:
When the hoist is connected to electrical power, anyone with a Controller can cause it to activate. Before
plugging in the lift or working on any part of the lift always be sure that no one is pushing any buttons on any hand held
Controller.
9.2. Controller Access:
without supervision. The Controller Storage Box has a hasp and can be locked using a customer supplied lock.
9.3. Power Source:
!"You have an AC motor that requires 120 volt AC power.
!"Your lift should never require more than 15 amps of electrical power.
!"Avoid plugging your lift into any circuit that cannot support at least 20 amps or is shared with heavy machinery that
might, together with the lift, trip the circuit breaker.
!"GFI protected electrical outlets must be used in all locations that might be exposed to water.
!"You may use an extension cord to bring power to your lift, but it must be 12 gauge or thicker.
!"Be sure that electrical power cords will not be crushed, punctured or have their insulation worn through.
!"When installing your lift anywhere where the power cords may be exposed to water you must use weatherproof
extension cords and weatherproof extension cord connectors.
under the Armed Base.
Controllers should always be kept away from children or those who should not operate the lift