Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 Assembly Instructions Manual - Page 5
Browse online or download pdf Assembly Instructions Manual for Toy Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910. Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 10 pages. 1:72 metal kit
Print PageD Assemble the wheels.
(1) Paint the appropriate tyre areas of the cast metal tyres matt black. Do
not paint the recesses where the spoke discs will be attached.
(2) Apply your preferred adhesive in the recess on one side of a cast metal
tyre, then attach the conical spoke disc as shown in Figure 3.
(3) When the adhesive is dry/cured, turn the wheel assembly over and
attach the second spoked disc to the other side. Leave this adhesive to
dry/cure.
(4) Do steps 1 D (2) and 1 D (3) again for the other wheels.
2 WING ASSEMBLY
A Remove the upper and lower wings, wing spars, interplane frames,
aileron spars and ailerons from the frets and remove any burrs from the
attachment tags.
B Fold all the ribs on each wing through 90°.
C Engage the slots in the wing spar in the slots in the ribs of each wing.
Make sure that they are symmetrical, then bond the wing spars in place.
D Attach the interplane frames between the upper and lower wings to form
the wing assembly as shown in Figure 4 below.
NOTE: The upper wing has a
continuous trailing edge in the
centre section (the lower wing has
it cut away for clearance of the
propeller and engine).
Figure 3
Figure 4
AILERON FRAME
AILERON
SPAR
BELL CRANK