GREAT PLANES EP YAK 55 3D Instruction Manual - Page 9

Browse online or download pdf Instruction Manual for Toy GREAT PLANES EP YAK 55 3D. GREAT PLANES EP YAK 55 3D 16 pages.

Print Page

2. Place the original servo arm over the screw, and glue

the top of the arm to the extender with thin CA. Some servo

arms have small flanges projecting from the top. If your

servo arms have these flanges, sand them off before gluing.

3. Glue a servo into the top of the rear servo cutout from

the left side of the plane. The output shaft should be toward

the rear. Center the servo with your radio and screw the

extended arm onto the output shaft with the arm oriented

straight down.

4. Glue the other tail servo into the cutout from the right side

of the plane side with the output shaft toward the rear. Center

the servo with your radio and screw the extended arm onto the

output shaft with the arm oriented straight down.

5. Center your aileron servo with your radio and screw

the extended double-sided arm onto the servo. Glue the

aileron servo into the cut out in the fuselage.

Install the Control Horns & Pushrods

1. Install the Z-bend end of the elevator pushrod into the

elevator servo arm.

2. Connect the other end of the elevator pushrod to the outer

hole on the elevator control horn using a micro FasLink.

3. Cut a slot in the rudder in the location shown. This slot

cuts through part of the rudder hinge for strength.