GREAT PLANES SU-31 Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Toy GREAT PLANES SU-31. GREAT PLANES SU-31 16 pages. Park flyers series

Print Page

Install the Receiver and Battery

1. Plug the elevator and rudder servos into the receiver.You

will also probably need a 6" [152mm] servo extension wire for

the speed control. Install the receiver in the receiver

compartment with a short piece of the supplied hook and loop

mounting tape. The photo shows a Futaba R114F four channel

receiver. Note in the photo how the wires are routed. When the

wing is installed, the aileron servo wire will come down the

opening in the fuselage at the upper left of the photo.

2. Extend the receiver antenna to its full length and

route it to the tail skid. Use clear tape to hold it to the side of

the fuselage.

3. Install the hook and loop mounting tape for the battery

in the battery compartment. We used four short pieces of

hook material. On the battery, we mounted one long piece of

loop material. This allows the battery to be moved within the

battery compartment to help balance the model.

Install the Motor

INSTALLING A KONTRONIK MOTOR

1. Trim the foam

fuselage as needed

to accommodate the

motor and wires from

the motor.

2. Drill a 3rd hold to for a zip tie.

3. Install the motor using the supplied nylon tie straps.

Note: The tie straps may not hold the motor tight enough to

prevent it from twisting slightly at full power with the prop

installed. If this happens, put a small drop of CA on the rear

of the motor where it touches the fuselage.

INSTALLING A MEGA CAN 16/15/3 BRUSHLESS MOTOR

1. Install your motor on the model with the included nylon

tie-wraps. The motor should be positioned just behind the