HiB Larino 77403000 Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Personal Care Products HiB Larino 77403000. HiB Larino 77403000 2 pages. Led mirrors with charging socket, led back-lit mirrors, fluorescent mirrors

Print Page
Wiring Diagram (Fig. B)
Wiring Diagram
Live is Brown
Earth is Green and Yellow
Neutral is Blue
LUMINAIRE
How to Isolate the sensor so you can switch
ON & OFF with a mains switch (Fig. 2)
How the mirror is wired.
live
earth
neutral
Charger socket/transformer
Sensor switch controller
LED driver
Heated mirror pad
How to isolate the sensor.
live
earth
neutral
Charger socket/transformer
Sensor switch controller
LED driver
Heated mirror pad
Rewire the mirror as shown in the diagram above. HiB recommends
that all electrical bathroom products should only be fitted by a
suitably qualified, Part P registered electrician.
For further assistance on isolating the sensor please contact us at:
Tel:
+44 (0)20 8441 0352
Email:
WEEE compliance
Must not be mixed with general household waste
T:
+44 (0)20 8441 0352
F:
+44 (0)20 8441 0219
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the interest
of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.
live
Live supply can be Red or Brown
earth
Earth supply is Green and Yellow
neutral
Neutral supply can be Blue or Black
MAINS SUPPLY
E:
Lamp Replacement
LED Mirrors
In the unlikley event that the LED light strip should fail (Not
applicable to Casey & Summer mirrors) please contact HiB Customer
Services for a replacement part at the address shown below.
Fluorescent Mirrors
Casey & Summer Require a T9 Round Lamp, Maximum 40 Watts
Skye Requires a T9 Round Lamp, Maximum 32 Watts
CAUTION: The surface of the lamp may become extremely hot!
Allow at least 30 minutes after lamp failure before replacing...
1.
Turn off the mains electrical supply and disconnect the wiring
How to isolate the sensor.
between the mains electric and the mirror.
2.
Detach mirror by removing screws on the exterior of the frame.
3.
Carefully grasp the failed lamp and lift upwards to remove the
lamp from the lamp holder.
4.
Carefully push the replacement lamp into the lamp holder.
5.
Ensure the heated pad cable is connected and slide the mirror
back onto the frame. Insert the screw, and tighten to secure.
6.
Reattach the mirror front to the frame ensuring that the heat
live
earth
pad and lighting cable are reconnected and clipped away neatly.
neutral
7.
Switch the mains supply back on.
Charger socket/transformer
Sensor switch controller
LED driver
Heated mirror pad
hib.co.uk