HiB Xenon 50 Installation Leaflet - Page 2

Browse online or download pdf Installation Leaflet for Personal Care Products HiB Xenon 50. HiB Xenon 50 4 pages.

Print Page

Quality Bathroom Products

Fixing Preparation

Fixing Brackets

Wall Hung Installation

1. Position the cabinet in a suitable location

(according to the zonal diagram on the back

page) ensuring that the mains supply cable

is within reach of the cable connection point

of the cabinet. Carefully mark the desired

position of the cabinet using a soft pencil,

ensuring it is level.

2. Remove the cabinet from the wall and using

a spirit level, mark a horizontal line below the

original pencil mark, taking into account the

location of the mounting points (Fig. A). Place

brackets on the new line paying attention

to the distance the hangers on the cabinet.

Carefully mark the position of the holes using a

soft pencil. (Fig. B)

3. Before drilling, ensure there are no hidden

cables of pipes behind the mounting point.

Using a suitable drill bit, drill holes in the

marked positions to a suitable depth.

4. Insert wall plugs level with the surface of the

wall. If fitting to a tiled surface, wall plugs

should be inserted below the tile surface to

avoid cracking. NB. For plasterboard walls,

REAR VIEW

Mounting Points

Suggested location

of internal ﬁxing hole

(Fig A)

(Fig B)

Hanger Adjustments

specialist fixings should be purchased from any

DIY or hardware store.

5. Fix the brackets to the wall using the screws

provided.

6. Carefully remove the small screws along the

top front edge of the cabinet to gain access to

the internal panel(s). (Fig. C) Keep screws in a

safe place

7. Temporarily hang the cabinet ensuring the

claws on the hangers are securely located on

the wall brackets. Using a spirit level adjust the

cabinet via the screws on the hangers. (Fig. C)

8. Mark the position of the internal fixing hole

and remove the cabinet. Using a suitable drill

bit, drill a hole and insert a wall plug as per

stage 4 above.

9. Connect the prewired cable at the rear of

the cabinet to the mains supply cable using

a suitable terminal block (not supplied)

according to the wiring diagram on the back

page.

10. Re - hang the cabinet in position, tighten the

screws on the hangers (Fig.C) and secure the

Angle Adjustment

Claw In/Out

Adjustment

(Fig C)