HiB 79602000 Fitting Instructions Manual - Page 6

Browse online or download pdf Fitting Instructions Manual for Bathroom Fixtures HiB 79602000. HiB 79602000 8 pages.

Print Page

Installation

It is recommended that this product is installed by two people.

Position the mirror in a suitable location according to the zonal diagram - Fig.

1, ensuring that the domestic electrical mains supply is within reach of the

cable connection point of the product.

2. Carefully mark the position of the mirror using a soft pencil ensuring it is level.

Remove the mirror and mark the mounting points, see Fig. 2. Please ensure

that all marked mounting points accurately match up with the fixing

points on the mirror.

3. Using a suitable drill bit, drill holes in the marked positions to a suitable

depth. If drilling through tile, use a ceramic drill bit.

4. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface,

wall plugs should be inserted below the tile surface to avoid cracking. NB.

For plasterboard walls, specialist fixings should be purchased, available

from any DIY or hardware store.

5. Screw supplied fixings into wall plugs.

6. Ensure the domestic electrical mains supply to which the mirror is being

connected is turned off. Connect the domestic mains supply to the terminal

box according to the wiring diagram, see page 3.

7. Remove the backing paper from the adhesive pads, see Fig. 2.

8. Hang the mirror in position and ensure the adhesive pads are secured to the

wall.

9. Switch the domestic electrical mains supply for the mirror back on.

To switch on/off, see Fig. 3.

Press the Power switch to turn the mirror on/off.

2. Heated pad is on when the mirror is illuminated.

To adjust the colour temperature (CTC), see Fig. 3.

Press the CTC switch once to change the colour temperature to a preset level.

The direct frontal and backlit ambience will work in unison.

2. There are 4 pre-set temperatures that cycle through warm, daylight,and cool

colour temperatures.