AFG 3.0 AE User Manual - Page 5

Browse online or download pdf User Manual for Elliptical Trainer AFG 3.0 AE. AFG 3.0 AE 20 pages.
Also for AFG 3.0 AE: User Manual (20 pages)

Print Page
ASS E MB LY ST EP 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
NOTE: STEPS C-E ARE 3.0 AE ONLY.
C) Slide FOOT LEVELER AXLE through MAIN FRAME TUBE. (The FOOT LEVELER AXLE is on top of bottom
styrofoam, beside the side shroud).
D) Slide left and right FOOT LEVELERS onto the AXLE.
E) Attach FOOT LEVELERS to the FOOT LEVELER AXLE using 2 BOLTS with BLUE THREAD LOCk (B) and
2 FLAT WASHERS (C).
3.0 AE ONLY
FOOT LEVELER AXLE
HARDWARE BAG FOR STEP 1 CONTENTS :
BOLT (A)
20 mm
Qty: 2
NOTE: 4.0 AE ONLY USES BOLT (A) WHILE 3.0 AE USES ALL HARDWARE SHOWN
3.0_4.0 AE_Rev.1.6.indd 8-9
MAIN FRAME
FRONT STABILIZER TUBE
MAIN FRAME
BOLT (A)
FRONT STABILIZER TUBE
BOLT (A)
FOOT LEVELER
BOLT (B)
CAP THINGY
FLAT WASHER (C)
MID-STABILIZER COVER
STABILIZER BAR
BOLT (B)
FLAT WASHER (C)
20 mm
16 mm
BLUE THREADS
Qty: 2
Qty: 2
ASSEMBLY STEP 2
CONSOLE MAST
WATER BOTTLE CAGE
BOLT (D)
TOP CAP
A.
Open HARDWARE BAG FOR STEP 2.
Slide CONSOLE MAST BOOT and TOP CAP onto the bottom of the CONSOLE MAST.
B.
C.
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
DO NOT PINCH WIRES!
D.
Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (E), 4 WASHERS (W) and 4 SPRING WASHERS
(Y)in the front and 2 BOLTS (F), 2 WASHERS (W), 2 SPRING WASHERS (Y) and 2 NUTS (X) from the side.
E.
Attach the WATER BOTTLE HOLDER to the mast using 2 BOLTS (D).
HARDWARE BAG FOR STEP 2 CONTENTS :
BOLT (B)
BOLT (D)
15 mm
Qty: 2
WASHER (W)
FLAT WASHER (C)
19 mm
Qty: 6
BOLT (E)
NUT (X)
SPRING WASHER (Y)
WASHER (W)
MAIN FRAME
BOLT (F)
SPRING WASHER (Y)
WASHER (W)
BOLT (E)
12 mm
Qty: 4
NUT (X)
SPRING WASHER (Y)
Qty: 2
15.4 mm
Qty: 6
BOLT (F)
70 mm
Qty: 2
8/27/07 3:36:28 PM