DaytonAudio HTA200BT User Manual - Page 5
Browse online or download pdf User Manual for Amplifier DaytonAudio HTA200BT. DaytonAudio HTA200BT 12 pages. 200w integrated stereo hybrid tube amplifier
Print Page
Rear Panel
10. DIGITAL (OPTICAL) INPUT
11. SUBWOOFER OUTPUT
Use a single RCA cable to connect the SW OUT
to a powered subwoofer or separate subwoofer
amplifier.
This will output a full range mono signal and the
volume output will change depending on the position
of the front panel volume control.
NOTE: The output will signal will be interrupted
when headphones are connected on the front of the
amplifier.
12. BLUETOOTH ANTENNA
Connect the supplied Bluetooth antenna here for
optimum signal strength.
13. GROUND TERMINAL
14. AC VOLTAGE SELECTOR SWITCH
The unit is set at the factory for 110V operation. For
220V operation, move the voltage selector switch
to the 220V position. When operating at 220V the
internal fuse located in the IEC socket should also
be changed. In most 220V applications a separate
power cord will be required and is not included.
15. PC-USB INPUT
16. DIGITAL (COAXIAL) INPUT
17. LINE LEVEL (AUX) INPUT
18. PHONO INPUT
19. SPEAKER OUTPUTS
Using insulated 2 conductor wire to connect to
speakers. The polarity, positive (+), and negative (-)
for all speaker and amplifier connections must be
consistent so both the left and right speakers are
in phase.
NOTE: The speaker outputs are not bridgeable.
20. AC POWER INPUT
5