GAI-Tronics 257S Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Telephone GAI-Tronics 257S. GAI-Tronics 257S 8 pages.

Print Page

Models 256S and 257S Rugged Weatherproof S.M.A.R.T. Phones

If trouble is experienced with this equipment, please contact:

GAI-Tronics Corporation

P.O. Box 1060

Reading, PA 19607-1060 USA

800-492-1212 or 610-777-1374

If the trouble is causing harm to the telephone network, the telephone company may request you to

remove the equipment from the network until the problem is resolved.

This equipment uses the following USOC jacks: RJ11C

It is recommended that the customer install an ac surge arrester in the ac outlet to which this device is

connected. This is to avoid damaging the equipment caused by local lightening strikes and other

electrical surges.

This equipment is Hearing-Aid Compatible (HAC).

The telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or

other electronic device, including fax machines, to send any message unless such message clearly

contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission,

the date and time it is sent and an identification of the business or other entity, or other individual sending

the message and the telephone number of the sending machine or such business, other entity, or

individual. (The telephone number provided may not be a 900 number or any other number for which

charges exceed local or long-distance transmission charges.)

Installation Instructions

1. Open the front door of the weatherproof enclosure.

2. Remove the four outermost screws from the front panel assembly.

NOTE

If the optional tamper-resistant screws are installed, a GAI-Tronics Model 233 Tamper-Resistant

Screwdriver is required.

3. Carefully pull the enclosure apart until you feel a slight resistance on the left side of the enclosure.

4. Open the front panel to the left. You will find a 7-foot half-modular telephone cord attached to the

terminal board.

5. Pull on the front panel until the hinge plugs pull loose and separate the front panel from the rear

enclosure.

6. Mount the rear enclosure to the wall using four 1/4-20 machine screws with washers and nuts or four

#14 wood screws, depending on the mounting surface. See Figure 1.

7. Replace the front panel by inserting the hinge plugs into their associated recesses on the left side of

the rear half of the enclosure.

8. Verify proper termination of the modular telephone cord to terminal board TB1 for the method of

flash control in use. See Figure 2.

f:\standard ioms - current release\instr. manuals (42004)\42004-315b effective 5-2.doc

04/01

Pub. 42004-315B

Page: 3 of 7