ActiveFlame Ranch A Instruction Manual - Page 9

Browse online or download pdf Instruction Manual for Indoor Fireplace ActiveFlame Ranch A. ActiveFlame Ranch A 13 pages.

Print Page

Operation

Pre-Operation

CAUTION: Do not attempt to operate this appliance until you

have read and understand all Safety Information in this manual

and all assembly is complete and leak tests have been performed.

After reading all the instructions, make sure that all the fireplace

controls are in the OFF position. Plug the fireplace into a 15A/120V

outlet. Scew in the 2 recessed lights (Model EF10122 GY ONLY))

Operating Fireplace Controls

The controls are located on the top right of the screen.

Press this button to turn ON the fireplace. Press again

to turn off the fireplace and the fan will continue to

work for 60 seconds without heat.

Press this button to change the flame effect. By default,

the flame color is orange.

Press again to change flame color to blue. Press for the

third to change flame color to a mix of blue and orange.

Press this button to change flame intensity. Press

again to decrease the flame intensity. There are 6

light intensities for your selection. The flame optics

will go lower under the sequence of 6,5,4,3,2 and 1.

Pressing the button again will stop the flame effect.

Press this button to set the desired temperature.

When desired ambient temperature is reached, the

heater will automatically stop heating.

When the ambient temperature drops below the

desired temperature 2°C, the heater will resume

heating.

Operation By Remote Control

On Screen Display

Please contact [email protected] or 1-800-561-5550 for further assistance.

A - Flame Intensity Level (1-6)

B - Flame (ON/OFF)

C - Temperature

D - Self-timer activation

E - Power Indicator

E - Temperature

G - Temperature Scale (

Press this button to turn ON the

fireplace and the fan will continue to

work for 60 seconds without heat.

Press this button for timer function. The

letters '0H' to '8H' will appear on the

LED screen.

'0H' means there is no set running time and

heater will run continuously. The letters '1H' to

'8H' mean the number of hours that the heater

will operate before shutting off.

Press this button to toggle between the two tem-

perature scales. The corresponding Celsius (C) or

Fahrenheit (F) LED indicates the current setting.

For heat function - Press this button to turn on the

heat function.

Press again to turn off.

Press this button to change flame intensity. Press

again to decrease the flame intensity. There are 6

light intensities for your selection. The flame optics

will go lower under the sequence of 6,5,4,3,2 and 1.

Pressing the button again will stop the flame.

Press this button to change the flame effect. By

default, the flame color is orange. Press again to

change flame color to mixed orange and blue. Press

a third time to change the flame colour to blue.

Press to turn on the recessed side lights.

Press again to turn off the recessed side lights.

(Model EF10123 GY et EF10123GY2 ONLY)

No function in Model EF10122 GY.

Press up or down button to the desired temperature.

When desired ambient temperature is reached, the

heater will automatically stop heating. When the ambi-

ent temperature drops below the desired temperature

2°C, the heater will resume heating.

F or

JRHOME.COM