Greatneck 80122 Owner's Manual - Page 14

Browse online or download pdf Owner's Manual for Power Screwdriver Greatneck 80122. Greatneck 80122 17 pages. 4.8 v cordless pivoting screwdriver

Print Page

WARNING:

Have you read "BATTERY

OPERATED POWER TOOL SAFETY",

"CORDLESS SCREWDRIVER

SAFETY", "BATTERY & CHARGER

SAFETY" and "SYMBOLS" on pages

4, 5, 6, 7 & 8 of this Manual? If not,

please do so now before you operate

this tool. Your safety depends on it!

Every time you use the screwdriver

you should verify the following:

Screwdriver bit is the correct

type & size, not worn and not

damaged in any way.

Workpiece is properly secured.

Safety glasses are being worn.

Failure to follow these safety rules

can greatly increase the chances of

injury.

DRIVING SCREWS

When driving screws, care must be taken to

use the bit that correctly fits the head of the

screw being driven. Make sure you use the

largest bit size that will properly fit into the

head of the screw. The bits must also be in

good condition and not worn so they will

drive screws without slipping out of the

screw head.

Select the correct screwdriver bit for

the screw being driven.

NOTE: Use the magnetic hex bit

extension if longer reach is required.

Insert the bit fully into the screwdriver

collet (1) (Fig. 7).

Pivot handle to a comfortable position

(2).

ASSEMBLY & OPERATION

Insert the screwdriver bit fully into the

screw head (3).

While holding the screwdriver firmly

against the screw, press the right hand

side of the switch to start the

screwdriver and drive the screw.

When the screw is driven as far as

possible, release the switch and the

screwdriver will stop.

When the switch is released and the

screwdriver stops turning, the spindle

will automatically lock. Fully tighten the

screw by manually rotating the

screwdriver handle in a clockwise

direction (4).

Fig. 7