GreatWhite GW9500 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Swimming Pool Vacuum GreatWhite GW9500. GreatWhite GW9500 12 pages. Automatic pool cleaner

Print Page

1. Remove swivel assembly (Figure 13) from the top of

the cleaner by turning it 1/4-turn counterclockwise

and pulling straight up on it.

2. Turn cleaner upside down. Remove 4 screws and

remove lower body assembly from shroud.

3 . Turn lower body assembly right side up. Unsnap the

2 clips on the oscillator chamber cap (Figure 14A); lift

it off.

4. Pull the long gear shaft straight up (Figure 14A) by

the blocks on the ends of the shaft. Hold the seals in

the oscillator and the blocks on the shaft. The cam

may interfere with the shaft mounting post; if so, turn

it slightly on the shaft until it clears the post. The shaft

assembly can now be disassembled (Figure 14B).

5. Slide the long gear shaft out of the oscillator (with

gears, complete); make sure that you don't lose the

seals out of the oscillator which may fall out at this

point (Figure 14B).

5A. Oscillator seals are replaceable.

5B. Ratchet gear set and long shaft are replaceable as a

unit.

6. Remove the short gear shaft and gears (Figure 15); do

not lose the gears off of the shaft.

NOTE: Put one finger under the gear nearest the end

of the cleaner and lift straight up to remove the short

gear shaft. Do not twist or bend the shaft.

7. With a small screwdriver (such as a jeweler's screw-

driver), a pencil, or a pen point, depress and remove

the coil spring from the movable brush mounting

post (Figure 16). Replace the brush and the spring if

necessary.

8. The metal ratchet tab slides out of its slot sideways;

replace it by removing the center brushes and sliding

in a new ratchet tab until it is flush with the edge of

plastic holder (Figures 17 and 18). Replace the center

brushes.

9. The brush ring pops out of the cleaner body for easy

replacement.

10. If you need to replace the bumper, turn the shroud

and bumber assembly upside down and remove the

two screws holding the bumper to the shroud.

If you have any questions, please call 1-800-752-0183

ABOUT DISASSEMBLY

Figure 13

Long Gear Shaft

Figure 14A

Lift here –

Figure 15

1. Slide metal ratchet tab

toward end of cleaner body

Figure 17

Swivel

"Click" at

assembly

this point

3337 1098

Locked

Twist CCW

1/4 Turn

Ocillator

Chamber

Cap

Block

Clip

Cam

Block

1889 0795

Figure 14B

not here

This –

Not This

3327 1098

Figure 16

1885 0795

Figure 18

Pull Straight

1887 0795

1886 0795

2. Slide metal ratchet tab

down through cleaner body

1884 0795