Dayva HS041-2 Instructions Manual - Page 13

Browse online or download pdf Instructions Manual for Patio Heater Dayva HS041-2. Dayva HS041-2 19 pages. Premier outdoor heater

Print Page

DAYVA PREMIERE OUTDOOR HEATER

FOR YOUR SAFETY

READ BEFORE OPERATING

Important safety instructions which if not followed could endanger the personal safety

and/or property of yourself and others. Read and follow all instructions before attempting

to operate your Dayva Premier Outdoor Heater.

The minimum inlet gas supply pressure for the purpose of input adjustment

pressure:

LP (Propane) Gas 11.2 inches w.c.

Natural Gas 10.0 inches w.c.

The maximum inlet gas supply pressure for the purpose of input adjustment

pressure:

LP (Propane) Gas 1/2 PSI

Natural Gas 1/2 PSI

The required manifold pressure in inches of water column:

LP ( Propane) Gas 10.0 w.c.

Natural Gas 7.0 inches w.c.

WARNING:

Certain materials or items when stored under the heater, will be subjected to radiant heat

and could be seriously damaged.

Lighting, shutdown and control operations:

After fully assembling your Dayva heater, turn on main gas supply and carefully recheck

all fittings for leakage using soap/water solution (see page 10).

If leak is discovered, turn off gas immediately. Repair seal on fitting with standard

pipe seal compound certified by a regulatory agency resistant to LP Gas.

A. Make certain main gas supply shut-off valve is in the "ON" position.

B. Push and turn gas control dial to "OFF" Position.

C. Wait sufficient length time to allow gas which may have accumulated to escape.

(at least 5 minutes)

D. Push and turn Gas Control Dial to "ON" position. Depress and hold dial in while

pushing red igniter button several times until pilot lights.

E. Allow burner to burn approximately 30 seconds before releasing dial. If pilot does not

remain burning when dial is released, repeat operation allowing longer period before

releasing dial. Wait a sufficient length of time (at least 5 minutes) to allow gas which may

have accumulated to escape. Repeat lighting instructions. If burner still will not light see

"TROUBLE SHOOTING", (pages 16-17).