GAI-Tronics 297-103 Manual - Page 13

Browse online or download pdf Manual for Emergency Phone GAI-Tronics 297-103. GAI-Tronics 297-103 20 pages. Externally powered emergency phones

Print Page

S.M.A.R.T. E

XTERNALLY

Programming

All S.M.A.R.T. Phone models are programmable. The phone settings are initially programmed during

manufacturing and testing. Factory default settings can be found in Table R-1. The following section

provides instructions for programming basic features needed to initially set up the phone from another

touch-tone phone.

We recommend using a handset phone exclusively when programming the S.M.A.R.T. phone remotely.

If a speakerphone is used for programming, the background noise can lead to incorrect settings. Do not

use a cell phone.

TMA is required to access many of the programmable features of the emergency telephones. For

programming using TMA, refer to the on-line help provided with the software, or contact the GAI-

Tronics Field Service Department.

Read the entire programming section and carefully plan your programming before beginning the process.

For each setting that will be changed, we recommend writing down the key sequence from the Command

column of Table R-1, Basic Programming Commands. Having the programming information written

down allows you to enter the key sequence at a steady pace. This is important because the programming

sequence times out if there is a pause of more than 5 seconds during the programming sequence.

Complete the following steps to enter the programming sequence from a remote DTMF telephone:

1. Call the telephone to be programmed. (Do not use a cellular phone.)

2. Listen for a confirmation tone during ringing, which signals that the telephone has answered.

3. Press *** to enter the programming mode.

4. Wait two seconds.

5. Enter **0000 (0000 is the factory default maintenance PIN #.)

6. Enter *20. If the phone has successfully entered into the maintenance mode, the phone will respond

with six DTMF digits. If access to the maintenance mode is denied, the phone will respond with two

DTMF digits. If access is denied, repeat steps 5 and 6 to again request access.

7. Complete the desired programming. Refer to the Basic Programming Commands section for options.

8. Listen for a confirmation tone at the end of each programming sequence, which indicates the

programming change was accepted.

9. When finished programming, press *99 to exit the programming mode.

d:\standard ioms - current release\42004 instr. manuals\42004-377c.doc

08/06

ADA-C

OWERED

OMPLIANT

MERGENCY

HONES

PUB. 42004-377C

12 of 18

AGE