Automatic Technology Australia GDO-8 v1 EasyRoller II Installation Instructions Manual - Page 15

Browse online or download pdf Installation Instructions Manual for Garage Door Opener Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20 pages.

Print Page

13. FITTING THE SAFETY PHOTO

ELECTRIC BEAM SENSOR (OPTIONAL)

Locate the Photo Electric Beam (P.E.) normally closed contact

type in a strategic location within doorway. We recommend

150mm above the floor level and as close as possible to the

door opening, inside the garage. Remove shunt from P.E

connector (Fig. 16) and connect the wires from the P.E. wiring

harness as per Fig. 17.

Note: The wiring diagram is for ATA's Transmitter/Receiver

type photo electric beam: model: PE-2 (Order Code 90214)

with Wiring Harness (Order Code 01900).

Make sure to align the beams correctly. Follow the manual

supplied with the Photo Electric Beam.

WARNING; The location of the beam and manner in which

it is installed might not give safety protection at all times.

Check to make sure that the height of the beam and type

used give maximum protection possible.

14. MANUAL RELEASE

To switch the opener to manual mode simply pull the red

manual release handle down and release. To re-engage the

opener repeat the above action (Fig. 18).

Note: The door may move uncontrollably if the spring tension

is weak or not set properly or the door is unbalanced. If this

occurs do not use the door and contact your installer for

service.

The manual release handle can be locked to prevent unwanted

disengagement (where fitted). This is useful if the opener is

mounted on an exposed carport or perimeter door. To disable

the manual release turn the key clockwise to the locked position

as indicated on the label. To enable turn the key anti-clockwise.

15. RESET ALL FACTORY DEFAULTS

1. Turn power off.

2. Press and hold Set button.

3. Turn power on and continue holding Set until all LEDs are

off.

Note: This does not erase transmitter codes stored in memory.

16. RE-INITIALISING THE OPENER

To re-initialise the opener press and hold the Set Button for two

(2) seconds, the beeper will sound once. The door will start to

move and re-calculate force margins. The door can move

between the open and close limit positions up to four (4) times

(depending on the position of the door and the power up

condition). A single beep will be heard once the initialisation is

complete. The door is now ready for use.

PE BEAM AND FINAL SET UP

REMOVE

PE SHUNT

Model: PE-2

1 2 3 4 5

FIG. 16

FIG. 17

24V

FIG. 18