HID MaxiProx DFM Reader - 5375 Installation Manual - Page 7
Browse online or download pdf Installation Manual for Card Reader HID MaxiProx DFM Reader - 5375. HID MaxiProx DFM Reader - 5375 19 pages.
Print Page
®
MaxiProx
Installation Guide
Table 1: TB1 Connector Definition
1
2
Shield
+DC
Ground
Red
Drain
Table 2: TB2 Connector Definition
1
DATA 0
DATA/TD/RX+
Green
Note: On TB2, pins 1, 2 and 7 have multiple purposes, depending on the configured reader interface.
In the above table, the first description is for Wiegand, the second for Clock-and-Data, the third for
RS232, and the fourth is for RS422.
2.7
Dip Switch and Jumper Settings
Verify the default settings according to the model ordered, or set the DIP Switches and Jumper
positions according to the following.
Table 3: DIP Switch and Jumper Settings
Switch
1. Interface mode 1
2. Interface mode 2
3. Interface mode 3
4. Beeper control On/Off
5. Green LED flash
6. Single/Dual external LED
7. Serial Baud 1 control
8. Serial Baud 2 control
Table 4: Interface Jumpers Description - P3 and P4
P3 and P4
March 2012
3
Ground
Black
2
3
DATA 1
DATA
RTN
CLK/RD/RX
White
Default
Description
On
See Table 6: Mode Chart
On
See Table 6: Mode Chart
On
See Table 6: Mode Chart
On - beep after valid card read. Off - no beep after valid
On
card read.
Off - flash after valid card read. On - no flash after valid
Off
card read.
Off
Off - single line LED control. On - dual line LED control.
Off
See Table 7: Baud Rate Chart – RS232 and RS422
Off
See Table 7: Baud Rate Chart – RS232 and RS422
1-2
See Table 6: Mode Chart
© 2008-2012 HID Global Corporation. All rights reserved.
4
5
Tamper
Tamper
Common
Select
---
---
4
5
6
GREEN
RED
BEEPER
LED
LED
Orange
Brown
Yellow
Part No. 5375-901, Rev E.1
7
8
HOLD/
TX+
CARD
RS422
PRESENT
Blue
Page 7 of 19
9
TX-
RS422