Gaiam BALANCE BALL Setup, Workout Tips And Care & Safety Manual
Browse online or download pdf Setup, Workout Tips And Care & Safety Manual for Indoor Furnishing Gaiam BALANCE BALL. Gaiam BALANCE BALL 2 pages.
Print Page
CUSTOM FIT
BALANCE BALL
Setup, Workout Tips and Care & Safety Guide
Please read before setting up or using your Custom Fit Balance Ball® Chair.
TOOLS NEEDED
Balance Ball® pump (you may want to use a bicycle
pump or compressor for initial inflation).
SET-UP
1. Remove the ball from packaging and inspect for
shipping damage. It is normal for the ball to have
slight creases or fold marks when first inflated.
2. Before inflating the ball, use a tape measure or ruler
to mark 55cm or 22" on wall or floor, or place two
objects approximately 55cm apart. This will be your
guide for proper inflation size.
3. Make sure that the ball is at room temperature
before inflating.
4. Using the supplied pump, insert it into the inflation
hole in the ball. Inflate the Balance Ball® to the
desired height and firmness. DO NOT overinflate.
5. Remove pump from Balance Ball® and immediately
insert plug into hole (so head is flush with surface
of ball).
6. Never inflate the ball larger than 55cm or
22" in diameter.
For optimal performance, it may be necessary to
re-inflate your new Balance Ball® once or twice after the
initial inflation. Once your chair is assembled and the
Balance Ball® is inflated, re-check the ball size the next
day. If necessary, add additional air and check once
more the following day. Your new Balance Ball® may
need a day or two to "stretch" to its final size (which
should then fit perfectly in the base).
WORKOUT TIPS
1. Follow exercise instructions presented in
the program.
2. Always use the Balance Ball® Chair in an open area,
free of furniture or other items that could get in the
way while exercising.
3. Use a smooth and steady motion when performing
each exercise.
4. Perform exercise routines to the best of your ability
without strain.
5. Avoid holding your breath while exercising.
05-57904_CstmFit_BBallChair_CARE_RB2015.indd 1
CHAIR
®
CARE
1. Clear workout area of sharp objects that may
puncture the Balance Ball®. Use only on a smooth
surface.
2. It is not necessary to deflate the Balance Ball® after
use; however, slight leakage may occur over time.
Re-inflate when necessary.
3. Hand wash the Balance Ball® Chair with a soft cloth
and warm soapy water. Do not use harsh or abrasive
chemicals or cleaning tools that may scratch or
damage the Balance Ball® Chair.
4. Always check the Balance Ball® for nicks or scratches
before each use. If damaged in any way, do not use.
5. Avoid placing or rolling the Balance Ball® on
newspaper, photocopies or other materials printed
in ink, as ink may permanently mark ball.
6. Avoid exposing the Balance Ball® to rough, sharp or
abrasive surfaces, or to heat or excessive sunlight.
IMPORTANT SAFETY CAUTIONS!
Please read before setting up or using the Balance
Ball® Chair.
1. Consult with your doctor before beginning
this or any other exercise program.
2. Perform exercises in a slow and controlled manner.
3. Use the Balance Ball® Chair only on smooth surfaces.
Do not use the Balance Ball® Chair if deep scratches
or gouges exist.
4. Stop and rest if you feel dizzy or short of breath.
5. Use product only as demonstrated in the
workout program.
6. Please contact Gaiam for any product questions or
regarding any defects. Manufacturer and distributor
disclaim any liability, loss or damage caused by
its use.
CAUTION: DO NOT place Balance Ball® in contact
with woodwork, wood furniture or painted walls for any
period of time. Damage to finish may occur.
4/30/15 9:29 AM