Activeforever KA1000 Instruction Manual - Page 16

Browse online or download pdf Instruction Manual for Alarm Clock Activeforever KA1000. Activeforever KA1000 17 pages. Dual alarm clock with wireless alarm monitoring receiver

Print Page

7. How to match the ﬂash pattern for all extended receiver (KA1000EX):

Write on a cheat sheet the order of transmitters you are going to register on the ﬁrst extended

receiver (page 19 of this manual). Apply the same order when registering the second extended

receiver. There are 16 different patterns for 16 entries.

8. The clock responds to channel one with ﬁre alarm detector but not for the CO detector:'

detector after registering the transmitter with the clock to check on the operation of the system.

9. After a vacation the alarm does not work:

When the security mode is on, the alarm mode will be disabled. Turn the SCT mode off to make

the alarm mode to return to normal setting.

10. The clocks memory is full. How to register a new transmitter into the system:

Erase the memory. First unplug the AC power cord from the electrical outlet. Uninstall battery from the

compartment for at least 5 seconds. Connect the battery and plug the clock into an AC source. The

clock now is ready for a new set up. All transmitters in the system must be registered to the clock after

the memory is erased. You may use the cheat sheet in page 19 to register the transmitters.

11. The clock activates the door knock or telephone ringer but there is no one at the door or the

telephone did not ring:

Your neighbor may also be using the KA1000. Change the security code on the

transmitter and register with the clock again. (Please read change system security code

section page 9)

12. How to register a new transmitter to the extended receiver (KA1000EX):

Press and hold the light switch when pressing the test button on the transmitter until the red LED

on the extended receiver ﬂash one time.

13. How to clear the memory for the extended receiver (KA1000EX):

Press and hold the light switch until it ﬂashes 8 times all memory is now clear. You must register

all transmitters with the clock again.

14. The newly purchased extended receiver did not response to any transmitter:

Plug the extended receiver to AC outlet. Press and hold light switch until it ﬂashes 8 times. (To

clear all memory it may have) Register all transmitters to the receiver again. Press the test button

on the transmitter to test the operation.

15. The quake-alert transmitter did not work with clock or extended receiver:

The weather alert transmitter KWA300TX does not have vibration sensor installed. It is designed for

the alert device output for external siren device. To use with quake alert, you must use alarm

transmitter KA300TX attached on the siren of the quake alert. Do not forget to register the new

transmitter with the clock and extended receiver. Press test button after registering to test the operation.

16. Replace transmitter's battery:

Use philip screw

open lip

- 16 -

Click to pop out

the battery