Dynalink RTA770 Quick Setup Manual - Page 14
Browse online or download pdf Quick Setup Manual for Network Router Dynalink RTA770. Dynalink RTA770 16 pages. Adsl router/modem
Print PageADSL Router Quick Set-up Guide
If there is no designated ADSL jackpoint, any jackpoints may be used.
Connect the router directly into a jackpoint, or through the port marked
MODEM on a filter.
2. If the router's DSL light is already on, check if router is on line. Go to the Quick
Start menu as described in Section 5 – Getting On-line. If the router reports
"Your DSL router is ready to connect", you are not on line. Make sure the user
name and password have been entered in the exact format as specified by
the ISP.
3. Check the configuration of computer and router. If you still cannot browse,
perform a PING test as described in Q1-2, using these addresses:
(A) Ping www.dynalink.com.au (or any valid web address)
(B) Ping 205.178.180.16 (or any valid public IP address)
If both (A) & (B) reported failed response such as "request time out", and
you assigned an IP address to your computer manually. Go to Procedure (2)
of Section 4. Check that the router's IP (192.168.1.1) is entered as gateway &
DNS. If these settings are correct ping the computer's IP (eg. Ping 192.168.1.2).
If there is still no reply your network card may be faulty.
If (A) fails but (B) shows a response, this is probably a DNS problem. Go to
Procedure (2) of Section 4. Enter the router's IP (192.168.1.1) as DNS.
If both (A) & (B) show a response, your router is actually on line. The problem
may be with your browser setting. Try returning any custom settings of the
browser to default. If you have a personal firewall, disable it to see if it makes
any difference. Also you may try shutting down the computer and restarting.
Q3. Need to install router on a network that uses a different subnet
If the existing network already has a DHCP server, disconnect one computer from
the network. Connect the computer to the router. The host computer will be
assigned 192.168.1.2. You can change the router's IP so that it is consistent with
the network. Disable DHCP on the router.
Q4. Browsing is fine but I cannot run certain applications.
You need to set up virtual servers or DMZ host. See Section 7 on Firewall & traffic
restrictions.
Q5. The router's IP and/or administrative password have been modified. But
the details have now been forgotten.
You can restore the router to factory default by pushing a pin into the hidden
reset button located next to the power on/off button at the back of the router.
Push and hold for 5 seconds then release to reset router.