Dynalink 56USBPRO Quick Setup Manual - Page 3

Browse online or download pdf Quick Setup Manual for Modem Dynalink 56USBPRO. Dynalink 56USBPRO 7 pages. 56k usb pro modem

Print Page

Before you start

You must first decompress the modem drivers from the floppy disk supplied into

your hard disk.

1. Insert the floppy disk labeled "V.90/K56Flex FAX/MODEM Driver" into your

floppy driver.

2. Go to Start-Run. Browse to My Computer–Floppy (A:). Highlight the file

UFM560.exe, click Open-OK.

3. Click OK to start the WinZip Self-Extractor. When asked Unzip to folder, either

enter C:\DynalinkUSB, or enter a new folder of your choice, and then click

the Unzip button. The driver files will be copied to your hard disk in the folder

DynalinkUSB, or the folder you have chosen.

Connect the enclosed phone cable to the LINE jack of the modem and a wall

phone jack, then connect the enclosed USB plug to both the modem and a USB

port on your PC. Once the modem has been connected to your PC a prompt will

load – please proceed to Step 3.

USB Hub Users: If you intend on using the modem via a USB Hub, the Hub must

be self-powered. The modem consumes more power than a bus-powered port

can normally supply. Self-powered USB Hubs, which overcome this issue, are

available from Dynalink.

System will report that it has detected a new device Atlas Modem Board.

Windows XP:

Click Next. Select Install from a list or specific location - Next. Browse to the

folder C:\DynalinkUSB\winxp, or the folder you have chosen in Step 1 (3). Click

Next. System will report Found USB V.90 56k FAX MODEM. If a compatibility

message appears, click Continue Anyway. Click Finish to complete driver installation.

Windows 2000:

Click Next. Select Search for a suitable driver for my device – Next. Click Specify

a location. Browse to the folder C:\DynalinkUSB\win2k, or the folder you have

chosen in Step 1 (3). Click Next-Next. If Digital Signature Not Found appears

click Yes to continue and Finish to complete driver installation.