Dynalink DYWRT54 Quick Setup Manual
Browse online or download pdf Quick Setup Manual for Wireless Router Dynalink DYWRT54. Dynalink DYWRT54 2 pages. 54mbps
Print Page
54Mbps Wireless Router
Quick Setup Guide
DYWRT54
DYWRT54 QSG.indd 1
1. Connecting the Router
Before you install the router, you should have connected your PC to the Internet
through your broadband service successfully. If there are any problems, please
contact your ISP. After that, please install the router according to the following
steps. Don't forget to pull out the power plug and keep your hands dry.
a. Power off your PC(s), Cable/DSL modem, and the router.
b. Locate an optimum location for the router. The best place is usually near
the center of the area in which your PC(s) will wirelessly connect.
c. Adjust the direction of the antenna. Normally, upright is a good direction.
d. Connect the PC(s) and each Switch/Hub on your LAN to the LAN Ports on
the router, shown in the following figure.
e. Connect the DSL/Cable Modem/Ethernet to the WAN port on the router,
shown in the following figure.
71045242
Ver:1.0
f. Connect the AC power adapter to the AC power socket on the router,
and the other end into an electrical outlet. The router will start to work
automatically.
g. Power on your PC(s) and Cable/DSL modem.
h. When all of the devices boot up completely, make sure that the router's
LEDs light as follows:
Power LED: Lit up
System LED: Flashing
Link/Act LEDs(WAN&LAN): Lit up
WLAN LED: Flashing
2. Login to the Router
To connect to the router, you should set up the TCP/IP Protocol in "Obtain an IP
address automatically" mode on your PC(s). If you need instructions as to how
to do this, please refer to Appendix B in the User Guide on the Resource CD.
a. Connect to the router by typing http://192.168.1.1 in the address field of
web browser.
b. After a moment, a login window will appear. Enter admin for the User Name
and Password, in lower case letters. Then click OK or press Enter.
16/03/2007 3:35:14 PM