HID Vertx CS V100 Quick Installation Manual - Page 4
Browse online or download pdf Quick Installation Manual for Controller HID Vertx CS V100. HID Vertx CS V100 9 pages.
Print Page
- 1. QUICK START, VERTX (CS) V100 Door/Reader Interface Panel
- 2. Table of Contents
- 3. Introduction
- 4. Parts List (Included)
- 5. Product Specifications
- 6. Cable Specifications
- 7. Overview
- 8. Step 1 Preparations
- 9. What You Need before Getting Started
- 10. Step 2 Hardware Installation
- 11. Mounting Instructions
- 12. Wiring Vertx
- 13. Contact Information
VertX V100 (CS) Quick Installation Guide
Overview
The following outlines what is required to install the V100 Door/Reader Interface panel.
Step 1
Preparations
1.1 What you need before getting started
Prior to starting the installation, please completely read through this guide.
CAUTION: The V100 is sensitive to Electrostatic Discharges (ESD). Observe precautions while
handling the circuit board assembly by using proper grounding straps and handling precautions at
all times.
1.2 V100
1. If the V100 will be attached to the end of the RS-485 bus, install a
terminating jumper on the termination resistor pins P8 on the cover
(P10 on the PCB) of the V100.
2. If the V100 is being installed as part of an array, or in a third party
enclosure, follow the directions provided by the Integrator or Dealer.
August 2005
2005 © HID Corporation. All rights reserved.
Terminating
Jumper
Page 4 of 9