HID VertX EVO V1000 Installation Manual - Page 5
Browse online or download pdf Installation Manual for Controller HID VertX EVO V1000. HID VertX EVO V1000 19 pages.
Print Page
VertX EVO V1000 Installation Guide
Step 1
Connect
1.1
What you need before getting started
Prior to starting the installation, completely read this guide.
Reference the
Configuration
CAUTION: VertX controllers and panels are sensitive to Electrostatic Discharges (ESD). Observe precautions
while handling the circuit board assembly by using proper grounding straps and handling precautions at all
times.
1.2
V1000
1.
Verify the battery jumper is installed in the ON position, P10
connector.
2.
If installing a V1000 - Verify the RS-485 termination jumper is
in the Out position when there are no panels attached to the
port. If there are downstream interface panels attached, place
the termination jumper in the In position. The V1000 is shipped
with jumpers in the Out positions
1.3
Mounting Instructions
1.
Always mount the controllers and interface panels in a secure
area.
2.
Mount using the four mounting screws (provided) or other
appropriate fasteners. Place the fasteners in the corner holes
of the base.
3.
Stack the VertX EVO devices with or without the cover. Do not remove the plastic base. Position the VertX EVO
devices in such a way as to provide room for wiring, air-flow and cable runs.
CAUTION: Stacking the VertX EVO devices without the cover risks the danger of breaking the LEDS
unless spacers are used for separation.
July 2011
Checklist, page 15, and gather the information before proceeding with these instructions.
© 2003 - 2011 HID Global Corporation. All rights reserved.
Page 5 of 19