Gain SAGA1-L10 Operating Manual - Page 7

Browse online or download pdf Operating Manual for Remote Control Gain SAGA1-L10. Gain SAGA1-L10 8 pages. Industrial remote controller

Print Page

(3) Press DOWN pushbutton 4 times and release "STOP & UP" pushbuttons when red LED flash.

(4) Start the system as usual.

Note: (1) By follow the procedures above, all the radios of same model within its radio operating distance, might be

affecting by ID code remote setting.

(2) ID code remote setting only transmits data of ID code only.

(3) The position of magnetic key or Rotary key will not affect to the ID code remote setting.

Transmitter Batteries

2 AA size alkaline batteries are required for the transmitter. DO NOT use rechargeable batteries. During operation, the

LED flash green when battery power is full and flash red intermittent every 2 seconds when battery power is low. When

battery power is low, the operating distance will become shorter. For safety reason, replace new batteries immediately when

battery power is low.

Power Supply

SAGA1-L10 provides 3 different AC transformers and the power supplied to the SAGA1-L10 Receiver as below

(1) 48/110/220 VAC

(2) 110/220/380 VAC

(3) 48/220/380 VAC

Each AC transformer provides 3 different voltages to meet different application's need. Please follow

the procedures below to select the voltage.

Disconnect the power of receiver.

Remove connector plug of the transformer from its original position

Then insert connector plug into the new position

Transmitter LED Malfunction Alert

(A) Red LED flashing quickly (every 0.2 sec) when any pushbutton is pressed. The problem could be:

(1) One of the pushbuttons is jammed.

(2) The EMS mushroom has not been released.

(3) The transmitter is not properly Power-On according to the instructions.

Note: Please contact the distributor nearest you for further assistant if need.

(B) TX LED flashes slowly (every 0.5 sec intermittent). The problem could be:

The memory of the TX is defective. Contact the distributor for repair.

Troubleshooting

(A) TX LED remains ON with red light.

Solution: Please remove the batteries and insert again.

(B) The RX does not respond at all.