Gain Electronic SAGA1-K Series Installation & Operation Manual - Page 6
Browse online or download pdf Installation & Operation Manual for Remote Control Gain Electronic SAGA1-K Series. Gain Electronic SAGA1-K Series 17 pages. Industrial radio remote control
Print Page
2-2 Precautions
¡
Operating in an industrial facility is relatively dangerous; therefore, operator must
have taken the adequate trainings in using SAGA1-K system.
¡
Those who operate the machine should be healthy and have good judgment in
regard to safety.
¡
Although the SAGA1-K transmitter is so durable and resistant for the fluctuating
temperature, care still need be taken to prevent it from the severe impact or
pressure.
¡
During operation, if the power supply of the transmitter's batteries is insufficient,
the transmitter will send out EMS signal first to de-energize all of motion relays
inside the receiver to stop crane's moving, and then the LED indicator on
transmitter will flash in red constantly. At this moment, the batteries need to be
replaced and all of four batteries should be replaced at the same time.
¡
If the severe interference occurred the equipment should be stopped at once.
¡
Please take the batteries out when the equipment will not be used for a long time.
¡
Be sure to know the "Procedures of Emergency " as follows.
2-3 Procedures of emergency
In case of an Emergency, please follow the steps below and ask the distributor for
service immediately.
1. Press "EMS" button.
2. Turn the key to "OFF" position and remove it.
3. Switch off the main power of crane.
4. Advise the distributor to find out the reason.
5