Gainlab Audio DICTATOR GLA-TC1 Calibration Manual - Page 6

Browse online or download pdf Calibration Manual for Recording Equipment Gainlab Audio DICTATOR GLA-TC1. Gainlab Audio DICTATOR GLA-TC1 18 pages.

Print Page

STEP - PREPARATION

The unit shall be disconected from mains!

1.1

Check the VU meters on the front panel. Adjust the VU meter with

1.2

the front panel screw to make it show the -20dB position as close

as you can.

Now you can connect the unit to mains. Also connect your input

1.3

and output signal cables.

Turn it on and wait 15 minutes to warm up the unit.

1.4

Note:

The Attack, Release and Sidechain ﬁlter knobs are not used

through the setup process.

The following positions shall remain in the full process:

Attack – Fastest, Relase – Fastest, Sidechain Filter – Off

STEP - OUTPUT VU METER SETUP

Starting point:

Input signal : +4dBu 1kHz sinewave, on both channels

Switch positions: Mode-Bypass, Meter-Output meter

Measurement process: To measure: the VU meter on front panel

Adjust: VR15 and VR16 trimmer

Target: On both VU meters there shall be 0dB on the output scale

Version: GLATC2CalibrationManualV2.1