Gree 13-04594 Owner's Manual - Page 10
Browse online or download pdf Owner's Manual for Air Conditioner Gree 13-04594. Gree 13-04594 18 pages. Window air conditioner
Mode Pad ( )
Use to set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads
Delay ON
—When the air conditioner is off, it
can be set to automatically come on in 1 to 24
hours at its previous mode and fan settings.
Delay OFF
—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Delay 1–24hr
Press the
pad on the unit or
the
pad on the remote control. Each touch
Do not operate your machine when the outdoor temperature is below 0°C (32°F)
This air conditioner is not designed to operate in outdoor temperatures below 0°C (32°F).
It must not be used if the outdoor temperature is below 0°C (32°F).
Remote Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
The remote control signal has a range of
up to 6.4 m (20 feet).
Cool Mode
Use the Cool mode at
L
o
w
,
Speed for cooling. Use the Temperature Increase
Decrease
pads to set the desired temperature
between 18 °C and 30 °C (64°F and 86°F) in
0,5 °C (1 °F). 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool
setting or if turned from a fan setting
to a Cool
setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Energy Saver Mode
Controls the fan.
ON —The fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally used when the
room is unoccupied. NOTE: The fan may continue to run
for a short time after the compressor cycles off.
Increase
of the
unit or the
the remote control will set the timer in
1-hour intervals. The
while setting.
To review the remaining time on the
1–24hr
timer, press the
unit or the
ncrease
the I
Increa se +/ Decrease –
or the
remote control to set a new time if desired.
To cancel the timer,
until the light on the
Make sure nothing is between the air
conditioner and the remote control that
could block the signal.
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
M
d e
,
H
g i
h
or Auto Fan
Cooling Descriptions
/
For Normal Cooling —Select the Cool
and
temperature.
For Maximum Cooling — Select the Cool
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling — Select the
Cool mode and Low fan with a middle set
temperature.
OFF —The fan runs all the time, while the
compressor cycles on and off.
13
/ Decrease
pads on the
Increase +/ Decrease –
pads on
Set
light will turn on
Delay
Delay 1–24hr
pad on the
pad on the remote control. Use
/ Decrease
pads on the unit
pads on the
Delay 1–24hr
press the
Delay 1–24hr
pad goes off.
High
or Med
fan with a middle set
pad
mode
mode