Automation Networks Highway Plus ANC-100e User Manual - Page 7

Browse online or download pdf User Manual for Adapter Automation Networks Highway Plus ANC-100e. Automation Networks Highway Plus ANC-100e 19 pages. Ethernet to data adapter

Print Page

1. Configuration and Interface

ANC-100e

Ethernet to DH+ Adapter

LED labeled "DH+" indicates the current status of the DH+ network:

•

"LED Off" indicates that there is no application level traffic coming into or out of the device.

•

"LED blinks without any particular pattern of Green and Yellow" indicates that the device is

associated with the DH+ network and there is ongoing communication taking place with other

nodes on the network. Packet transmission causes Yellow LED to blink, packet reception is

indicated by a Green blink.

Accessing ANC-100e User Interface

IMPORTANT: Before proceeding, check that your PC's Network adapter is configured to match ANC-

100e IP settings. Also make sure the unit is connected to your computer or Ethernet network.

In case the previously configured IP settings were forgotten or lost and connection to the device

cannot be established anymore, please perform the factory reset described in chapter "Reset to

Default Factory Settings" of this manual.

1. Open any web browser and enter the ANC-120e IP address in the address bar. Default IP

address of the device is set to "192.168.0.230"

2. Press "Enter" key

3. Enter the username and password in the corresponding fields. By default, the username is set

to "admin" and password to "password"

4. Click "OK" button.

5. If you entered the correct login credentials, you will be presented with the main configuration

window.

User Manual 7