Hideaway Beds Next Bed King Assembly Instructions Manual - Page 2

Browse online or download pdf Assembly Instructions Manual for Indoor Furnishing Hideaway Beds Next Bed King. Hideaway Beds Next Bed King 7 pages.

Print Page

Section 2: YOKE ASSEMBLY

Assemble the Yoke Assembly components as shown. If you are installing the bed in a 16" deep cabinet,

fasten the Floor Yokes and Wall Mount Brackets together not to exceed a 15" projection from the base

board or wall. Secure the Yoke Assembly to the base or wall with the screws provided while following the

steps below. Match fasteners with the actual-size drawings to ensure you use the correct pieces.

Attach the Bottom Spring Tube (J) to the Floor Yokes (H).

M8x20mm Bolt (4pcs)

Attach the Wall Mount Brackets (G) to the Floor

Yokes (H) using the Bolts, Nuts and

Washers shown below. Place bolt heads on outside.

Do not tighten bolts now so you can adjust later.

M8x20mm Bolt, 2 Flat Washers, Nylock Nut (4 sets)

Attach Yoke Connector Bar (I) to the

Floor Yokes (H).

M6x18mm Bolt, Nylock Nut (2 sets)

Insert screws through Wall Mount Brackets (G) and into

Wall and Base Board at a downward angle.

8-3" (76.2mm) Flat Head Screw (8pcs)

Updated130717MWBS