Celestron PowerSeeker 114EQ Quick Setup Manual

Browse online or download pdf Quick Setup Manual for Telescope Celestron PowerSeeker 114EQ. Celestron PowerSeeker 114EQ 2 pages. Celestron powerseeker 50: brochure
Also for Celestron PowerSeeker 114EQ: Instruction Manual (10 pages), Quick Setup Manual (2 pages), Specifications (4 pages), Brochure & Specs (4 pages), Quick Setup Manual (2 pages), Quick Setup Manual (10 pages), Quick Setup Manual (2 pages)

Print Page

PowerSeeker 114EQ & 127EQ

Item# 21045

Your PowerSeeker 114EQ or 127EQ includes: optical tube w/

tube rings attached; tripod with center leg brace; equatorial

mount; 2 eyepieces; a 3x barlow lens, finderscope; 6 lb.

counterweight (#21049 has 6 lb. & 2 lb. counterweights);

counterweight bar; two slow motion cables; eyepiece

accessory tray; The Sky

Level 1 software, owner's manual.

All three legs should be the same length to provide a level

platform for the telescope.

Locate the equatorial mount and place the base of the mount

through the hole in the center of the tripod mounting

platform.

All manuals and user guides at all-guides.com

Item# 21049

PowerSeeker 114EQ shown

To set up the tripod, spread the legs outward until they are

fully extended and push down center leg brace.

Place the accessory tray on top of the tripod's center leg

brace. Thread the tray into the threaded hole in the center of

the leg brace.

From underneath the tripod mounting platform, thread the

attached mounting bolt into the hole on the bottom of the

equatorial mount.

Questions or Problems with Set-up?

CONTACT:

Celestron Technical Support: 310

Quick Set-up Guide

Extend the center portion of each of the three tripod legs

down 6-12". Use the three tightening screws located at the

bottom of each leg to secure the extended legs in place.

Properly assembled, the accessory tray should appear as

pictured above.

Thread the latitude adjustment screw into the equatorial

mount until it is touching the inside of the mount.

803

5955