Dynamic Dynatrap 3 Owner's Manual

Browse online or download pdf Owner's Manual for Insect Control Equipment Dynamic Dynatrap 3. Dynamic Dynatrap 3 3 pages. Flying insect trap
Also for Dynamic Dynatrap 3: Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (3 pages), Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (2 pages), Owner's Manual (2 pages)

Print Page
Dynamic Dynatrap 3 Owner's Manual
ASSEMBLY GUIDE
MODEL: DT1200/DT12S0
ASSEMBLY INSTRUCTIONS
I.
Unpack the unit, and place ii on the
ground.
Pull the cord light through the pole stand as in Figure
l.
2. Insert upper and lower tubes and press the spring bulge to ensure both tubes ore securely placed, os in Figure
2.
3. Insert the connector piece into the stand
hose.
Align pole and connect by screwing nut os in Figure
3.
4.
Your Dynatrap is now ready to be connected to the electrical outlet.
5.
Turn switch
on.
INSTRUCCIONES PARA INSTALACION
I.
Desempaque la unidod,
y
col6quela en el
piso.
Joie firmemente el cable atraves del tubo de lo hose, como se muestra en
lo Figura l.
2.
lnserte el tubo superior e inferior
y
opriete el bot6n con resorte poro osegurorse que ombos tubos son colocodos seguro-
mente, como se muestra en lo Figura
2.
3.
lnserte el conector de plastico en lo porte inferior de lo
hose.
Alinee el tubo
y
conecte por medio de lo tuerco de plastico,
como se muestro en lo Figura
3.
4.
Su Dynatrap esta lista para ser conectoda a la fuente de
corriente.
5. Enciendo el
switch.
Figure l
Pull the cord through the pole stand
....................
upper tube
Figure 2
Insert both upper and lower tubes together and
make sure the spring bulge is securely
placed.
press the spring bulge
---
•
Figure 3
Insert bottom connector piece into stond
base.
Align pole and connect by screwing
nut.
/
On/Off switch
locoted under the
roin cover
I
Figure 4
0
0
Place the unit in
upright position
Ground
•